CADDX NX-6 Manual de Instalação descarregar pdf (Página 78)

GE Security

LOCATIONS 207-211 - RESERVED

LOCATION 212 – PROGRAMMING THE LCD KEYPAD ADDRESS (1 segment, numerical data)

When using the XSIA dialler format, the system requires at least 1 LCD keypad. The

panel will get the zone descriptions from the first language from that LCD keypad which

has the address defined in location 212. If your system has an LCD keypad it is

recommended that it will be placed in location 1 keypad 1. This will allow location 212 to

be left at the factory default. If the LCD keypad is selected as something other than

partition 1 / keypad 1, program the appropriate address in location 212. Select the

address from the location chart.

Keypad Part 1 Part 2

1 192 193

2 200 201

3 208 209

4 216 217

5 224 225

6 232 233

7 240 241

8 248 249

LOCATION 213 – PROGRAMMING THE COUNTRY CODE (1 segment, numerical data)

The NX-6 has the ability to set different “country codes”. Each country code has specific

default settings. Before start programming the NX-6, it is important to select the country

code that is required (see table below). Once the country code has been selected, it will

remain set, even after an installer reset. When changing the country code during

programming, all existing programming will be cleared to the defaults for that country.

Code Country

0 No country (default)

1 Holland

2 Belgium / Poland

3 Sweden

4 Italy

5 Spain / Portugal

6 Greece

7 South Africa

50 US

NX-6-EUR Installation manual Page 78 23/12/04

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 103 104

Sem comentários

CADDX NX-6 Manual de Instalação Página 78