CADDX NX-6 Manual de Instalação descarregar pdf (Página 17)

GE Security

NOTE:

ANY MASTER ARM/DISARM CODE CAN ADD OR CHANGE A USER CODE IF THE

MASTER CODE HAS ACCESS TO THE SAME PARTITIONS AS THE CODE BEING

ADDED/CHANGED. CONSEQUENTLY, WHEN PROGRAMMING THE USER CODES

FOR A PARTITIONED SYSTEM, LEAVE AT LEAST ONE CODE WITH ACCESS TO

ALL PARTITIONS. UNLESS YOU DO THIS, YOU WILL NOT BE ABLE TO ADD NEW

USERS. (THE CODE CAN BE THE “GO TO PROGRAM CODE”, IF ENABLED IN

LOCATION 43). IF YOU WANT TO LET THE END USER ADD NEW CODES, YOU

MUST REMOVE THE PARTITION AUTHORITY FROM ALL BLANK CODES.

[*]-[CHIME] ACTIVATING WALKTEST:

1. Enter [*]-[CHIME].

2. Enter [Master code].

3. Activate all sensors to test. Each activation of a sensor is confirmed with a “ding

dong” sound with a corresponding flashing zone-indicator.

4. Enter [Master code]. Herewith the walktest-mode is left.

Remark: Walktest mode is not possible if any partition is armed or if the

communicator is active.

Additional keypad functions are described in the appropriate user manual

NX-6-EUR Installation manual Page 17 23/12/04

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 103 104

Sem comentários

CADDX NX-6 Manual de Instalação Página 17