CADDX NX-6 Manual de Instalação descarregar pdf (Página 16)

GE Security

[*]-[5] CHANGING USER CODES

1. Enter [*]-[5]-[master code]- the “Ready” LED will flash.

2. Enter the 2 digit user number (always 2 digits, such as “03” for user 3)- the “Ready”

LED will illuminate steadily.

3. Enter the new user code designated for the person in question - the “Ready” LED

will flash, indicating that the code has been accepted. If the code is rejected, the

sounder will beep 3 times.

4. If another user code needs to be programmed, return to step 2.

5. Press [#] while the “Ready” LED is flashing in order to exit the user code

programming mode.

6. Pressing four times (for 4-digit code) can erase a user code or six times (for 6-digit

code) the “Cancel” key.

[*]-[6] ASSIGNING AUTHORITY LEVEL

1. Enter [*]-[6]-[master code]- the “Ready” LED will flash.

2. Enter [2 digit user number] (always 2 digits, such as 03 for user 3)- the “Ready” LED

will illuminate steadily and the “Instant” LED will flash. Refer to the chart below for

the description of each LED. Turn on the LED for the features that you want.

LED ATTRIBUTES IF LED 8 IS OFF LED ATTRIBUTES IF LED 8 IS ON

1 Reserved 1 Activate output 1

2 Arm only 2 Activate output 2

3 Arm only after closing window 3 Activate output 3

Master arm/disarm (can program

other codes)

4 Activate output 4

5 Arm/disarm code 5 Arm/disarm code

Allowed to bypass zones (see

location 23)

Allowed to bypass zones (see

location 23)

7 Code will send open / close reports 7 Code will send open / close reports

If this LED is on, LED’s 1-7 will use

the chart too the right

If this LED is off, LED’s 1-7 will use

the chart on the left

1. Enter [*]: The “Instant” LED will illuminate steadily.

This moves you to the ‘partition enable’. (This tells the system which partition this

user can arm/disarm.) LED’s 1-8 will light up for each partition that the user is

authorised to arm/disarm. To change any of these numbers, press 1-8 to permit or

deny access to the user. (Example: If LED 2 is lit, then the user has been assigned

access to that partition. By pressing the [2] key, the LED will go out, indicating the

user has been denied access to that partition.)

2. Enter [*]:

This brings you back to step 2 above. At this point, you may enter another user

number to which you can assign attributes. You may continue this procedure until

you have assigned authority levels to all user numbers; otherwise, you may press

the [#] key to exit the assigning authority level program.

NX-6-EUR Installation manual Page 16 23/12/04

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 103 104

Comentários a estes Manuais

Sem comentários

CADDX NX-6 Manual de Instalação Página 16

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso CADDX NX-6