CADDX NX-6 Manual de Instalação descarregar pdf (Página 32)

GE Security

ALPHANUMERIC CHARACTER TABEL

1 A 20 T 39 ä 58 n 77 #

2 B 21 U 40 ä 59 o 78 $

3 C 22 V 41 b 60 ô 79 &

4 D 23 W 42 c 61 ö 80 '

5 E 24 X 43 ç 62 p 81 (

6 F 25 Y 44 d 63 q 82 )

7 G 26 Z 45 e 64 r 83 *

8 H 27 0 46 é 65 s 84 +

9 I 28 1 47 è 66 t 85 ,

10 J 29 2 48 ê 67 u 86 -

11 K 30 3 49 f 68 û 87 .

12 L 31 4 50 g 69 ü 88 /

13 M 32 5 51 h 70 v 89 :

14 N 33 6 52 i 71 w 90 ;

15 O 34 7 53 î 72 x 91 <

16 P 35 8 54 j 73 y 92 =

17 Q 36 9 55 k 74 z 93 >

18 R 37 a 56 l 75 ! 94 

19 S 38 à 57 m 76 ” 95 °

EXITING THE PROGRAM MODE

When you have made all the desired changes in programming, it is time to exit the

program mode. Press the [Exit] key to exit this programming level, and go to the “Select a

Module To Program” level. If no additional modules are to be programmed, press the

[Exit] key again to exit the program mode. If there is a module to be programmed, you

can select it by entering its address, followed by the [#] key (see “Selecting the Module To

Program” above). The procedure for programming these devices is the same as for the

control panel, except that the locations will be for the module selected.

Note: the timeout for the program mode is 15 minutes.

LOADING FACTORY DEFAULTS

To load the factory defaults, enter the program mode using the above procedure, then

type [9]-[1]-[0]-[#]. The keypad will beep 3 times to show that loading is in progress. The

loading takes about 6 seconds.

ENROLLING MODULES AND KEYPADS

For supervision purposes, the presence of all keypads, zone expanders, wireless

receivers, and any other modules connected to the data terminal can automatically be

found and stored in the NX-6’s memory. This allows the control panel to supervise these

modules. Note: All modules should be connected and set to unique addresses before

modules are enrolled. To enroll the modules, enter the program mode of the NX-6 control

panel as described above. If necessary, go on to program the rest of the control panel

and devices. When you exit from program mode, the control panel will automatically

enroll the devices. The enrolling process takes about 12 seconds, during this time the

“Service Screen” will be displayed. If a module has been enrolled but it is not detected by

the control, the “Service Screen” will be displayed.

NX-6-EUR Installation manual Page 32 23/12/04

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 103 104

Comentários a estes Manuais

Sem comentários

CADDX NX-6 Manual de Instalação Página 32

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso CADDX NX-6