CADDX NX-6 Manual de Instalação descarregar pdf (Página 53)

GE Security

LOCATION 43 - GO TO PROGRAM CODE PARTITION AND AUTHORIZATION (2 segments, feature

selection data)

The “Go To Program Code” can be used as a standard arm/disarm code. When using the

code to arm or disarm, the user ID is 255. (It is not possible to change this code in the run

mode).

Segment 1

1 = Reserved

2 = On: enables “Go To Program Code” as an arm only code

3 = On: enables “Go To Program Code” as an arm only, after closing

4 =

On: enables “Go To Program Code” as a master arm/disarm code

(can change user codes)

5 = On: enables “Go To Program Code” as an arm/disarm code

6 = On: enables “Go To Program Code” to bypass zones

7 = On: enables “Go To Program Code” opening and closing reports

8 = Reserved

Segment 2

1 = On: enables the “Go To Program Code” for partition 1

2 = On: enables the “Go To Program Code” for partition 2

3-8 Reserved

) LOCATION 44 - DURESS CODE (6 segments, numerical data)

Location 43 contains the “Duress” code. This Location contains either 4 or 6 digits. If the

6-digit code option is enabled in location 41, THIS CODE MUST CONTAIN SIX (6)

DIGITS. If the 6-digit option is not enabled in location 41, the last 2 digits will be ignored.

If the duress code is programmed, it will work for all partitions.

NX-6-EUR Installation manual Page 53 23/12/04

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 103 104

Sem comentários

CADDX NX-6 Manual de Instalação Página 53