CADDX NX-8e Especificações descarregar pdf (Página 5)

NX-8E CONTROL

I. GENERAL DESCRIPTION

The NetworX NX-8E represents a new approach to security systems design. Drawing on our experience in the world

market as the largest exporter of USA manufactured controls, we have developed the most flexible, durable, and user-

friendly control ever seen in our industry. Featuring sophisticated software, which allows up to 240 users to interface with

192 zones, 8 partitions, and a host of integrated fire, access, verification, and input/output modules, all reported with the

most comprehensive and fast SIA and Contact ID formats. The NetworX design allows a fully loaded system to be housed

in one single metal enclosure, establishing for the first time, a logical solution and design response to modular systems. Up

to 32 modules can be added to expand the capabilities of the NX-8E. For product warranty information, please refer to the

GE Security Product Catalog.

II. BOARD INSTALLATION

Inside the can, several 2-holed insertion points have been constructed. This allows

for either vertical or horizontal placement of the modules. Notice that each insertion

point has two sizes of holes -a larger hole and a smaller hole.

Diagram 1

: The black plastic PCB guides are grooved on one edge where the PC

board will be seated. The end with the half-moon protrusion fits into the larger hole.

The smaller hole is for the screw.

Diagram 2

: Place the first black plastic PCB guide in the top insertion point, grooved

edge downward. The half-moon protrusion will be in the large hole. It does not

require force. Insert one of the provided screw into the smaller hole (from inside the

can) to secure it in place. A screwdriver should reach through the notch that runs the

length of the guide to tighten the screw. The second PBC guide should be

positioned opposite the first (grooved edge up) and placed in the lower insertion

point, using the same procedures described above. Once mounted, screw it in

securely.

Diagram 3

: The PC Board should slide freely in the grooves of both guides.

IMPORTANT!

1. If separate power supplies are necessary to accommodate additional devices, safety standards

require that each power supply be prominently marked with adequate instructions for removing all

power from the unit.

2. Dispose of used batteries according to the manufacturer’s instructions and/or local government

authorities.

3. Installation personnel should thoroughly read and understand the installation instructions and the

users manuals for the panel and all the accessories to be included with the system before attempting

to install a security system.



WARNING!

Replace only with Panasonic #LC12V4BP or Yuasa #NP4-12 battery. Observe polarity when installing a

new battery. Installing the battery backwards may cause damage to the panel. There is a risk of explosion

if the battery is replaced with an incorrect type.

NOTE

Electrical codes will vary depending upon the country and city where the system is installed. It is the

installer’s responsibility to ensure that the electrical installation is safe and conforms to all applicable

codes, laws, or regulations. Only qualified persons should connect this device to the mains supply.

1 2 3 4 5 6 7 8 9 10 ... 79 80

Comentários a estes Manuais

Sem comentários

CADDX NX-8e Especificações Página 5

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso CADDX NX-8e